An installing chain link fence is a cheap option to fence an area when the appearance of the fence is not important. The construction of a wire fence is quite simple, but the land that is not level can complicate the procedure. When a section of the metal fence must go up or down a slope, terminal posts must be at the beginning and end of the slope. The messages on the own inclination have to be perfectly vertical and a little higher than normal since the fabric is crossed at an angle.
Dig the hole, with the hole digger. The hole should be 30 inches deep in the center of the hole and six to eight inches wide. Use the paddle to make the bottom of the hole wider than the top so that the frost will not push the concrete block from the ground. Calculate the height of the pole installing chain link fence gate. Since the message is on a slope, it should be a few inches higher than normal.
But the exact height will depend on the height of the chain link fence post depth and the angle of the slope. The easiest way is to keep the chain linking the fabric up on that slope, and then measure the plumb fabric to the ground with a tape measure, ignoring the slope. Add two inches to the measurement if you are installing a terminal post, or subtract two inches if you are installing a line post.